You need to run the "splunk restart" command in the command prompt (CMD) or terminal on the host where the Splunk forwarder is installed. This will restart the Splunk forwarder service on that host and apply any changes made in the configuration files, such as deploymentclient.conf.
Yeah, this should be C I think. Assuming you just modified the deploymentclient.conf on the forwarder, you would restart the service on the forwarder, not the DS, to load the config into the service.
if "installed" means, that the splunk software was installed and the DS is configured already by deploymentclient.conf the next step would be to restart splunk on the forwarder.
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
NastyNutsu
3 months agoadamsca
10 months agoadamsca
10 months agotoney_mu
1 year, 2 months agoRodders2828
1 year, 4 months agoanonyuser
1 year, 4 months agocb42
1 year, 4 months ago