Exam PCNSE topic 1 question 276 discussion

Just be aware that this command is deprecated in Advanced Routing Mode(show routing protocol bgp peer)

"attempting to peer"

It is between show peer and show summary. Because show peer gives you more info about your peer config, which will need to be verified, B is the best answer. Show summary will give you less info about the peer config and more info about the peering session, which is not established anyways and is therefore less helpful.

This live community post has output from both "show peer" and "show summary" https://live.paloaltonetworks.com/t5/general-topics/bgp-quot-router-id-quot-and-multiple-peers/td-p/24305 - BOTH show the status / current state between the two devices. Show Peer: Peer status: Established, for 3657 seconds Show summary: peer peer1.4.1: AS 65002, Established, IP 10.10.10.4

Difficult to chose as both provide the BGP peer state: B. show routing protocol bgp peer C. show routing protocol bgp summary Probably B is a little bit more correct answer as the output is split by peers with additional details and there is also an option to add "peer-name <name>" which will filter output for only specific peer, summary shows them all.

https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA14u000000CpwaCAC&lang=en_US%E2%80%A9

Option B is correct. https://live.paloaltonetworks.com/t5/general-topics/monitoring-bgp-stats-from-palo-alto-panorama/td-p/24689

not sure here would be good to know. All the commands bar D) are valid syntax