ExamTopics Logo
Mail Us[email protected]
Menu
Nutanix Discussions
exam questions

Exam NCP-MCI v6.5 All Questions

View all questions & answers for the NCP-MCI v6.5 exam
Go to Exam

Exam NCP-MCI v6.5 topic 1 question 57 discussion

Actual exam question from Nutanix's NCP-MCI v6.5
Question #: 57
Topic #: 1
[All NCP-MCI v6.5 Questions]

A newly hired Nutanix administrator was tasked by the CIO to create a single VM on a test network. The network administrator stated that a native VLAN was used on the Cisco TOR switches with the following parameters:

IP address: 172.16.1.2 -

Network Mask: 258.255.252.0 -

Default gateway: 172.16.1.1 -

VLAN: 1 -
The same parameters were used to create a network profile on Nutanix, but when the VM was created, it had no L3 connectivity.
What should the Nutanix administrator do to fix this issue?

  • A. Use DHCP as opposed to static IP.
  • B. Change VLAN field from vian.1 to vlan.0.
  • C. Nutanix removed support for native VLAN.
  • D. Enable IPv6 on the VM.
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
by luis_vel at July 24, 2024, 6:14 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
JordansGhost
1 month ago
Selected Answer: B
Agree correct answer is B. Ignore the invalid subnet mask in written in the question. That must be a typo.
upvoted 1 times
...
panotwong
4 months, 2 weeks ago
Selected Answer: C
The correct answer is B. Change VLAN field from vlan.1 to vlan.0. Explanation: In many networking setups, VLAN 1 is treated as a default or "native" VLAN. However, on Nutanix AHV, if the network administrator specified that a native VLAN was used on the Cisco TOR switches, the correct setting in Nutanix would typically be VLAN 0 to match untagged traffic, which is treated as native VLAN traffic on most switches. Setting the VLAN to 0 allows the VM to use the untagged/native VLAN, ensuring proper Layer 3 connectivity in line with the network configuration on the Cisco switches.
upvoted 2 times
...
luis_vel
7 months, 2 weeks ago
B If native VLan was used in Cisco TOR switches and is the only configured the VM created should be configured to run in VLan 0, not is the best practice but answer this question.
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago