ExamTopics Logo
Mail Us[email protected]
Menu
Netapp Discussions
exam questions

Exam NS0-184 All Questions

View all questions & answers for the NS0-184 exam
Go to Exam

Exam NS0-184 topic 1 question 84 discussion

Actual exam question from Netapp's NS0-184
Question #: 84
Topic #: 1
[All NS0-184 Questions]

You have a 4-node ONTAP 9.8 cluster with an AFF A400 HA pair, and you are adding a FAS8300 HA pair to the cluster. The FAS8300 controllers are not new and were decommissioned from another cluster. You are asked to enable hardware-level HA on the FAS8300 controllers.

In this scenario, which shell is used on the FAS8300 controllers to enable this feature?

  • A. system
  • B. node
  • C. maintenance
  • D. cluster
Show Suggested Answer Hide Answer
Suggested Answer: C 🗳️
by e4468f6 at Sept. 3, 2024, 3:16 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
slizla
3 months ago
C - maintenance To verify and set the HA state of the controller module in Maintenance mode, follow these steps: 1. Enter Maintenance Mode: - Boot the system into Maintenance mode by interrupting the boot process with Ctrl-C and selecting the appropriate option. 2. Verify the HA State: - In Maintenance mode, display the HA state of the controller module using the command: ha-config show - The possible values for HA-state can be: - ha - mcc - mcc-2n - mccip - non-ha 3. Set the HA State (if necessary): - If the displayed HA state is not correct, set the HA state for the controller module using the appropriate command based on your configuration. For example: ha-config modify controller ha - Confirm that the HA state has been updated by running: ha-config show 4. Reboot the Node: - Once the HA state is correctly set, boot the node to ONTAP using: boot_ontap
upvoted 1 times
slizla
3 months ago
Sorry, answer is B - node From node shell you allow a node to boot into ONTAP software. The boot menu provides more options that are useful for troubleshooting and maintenance. To access boot menu, you must press Ctrl+C when you are prompted during the boot sequence.
upvoted 1 times
...
...
e4468f6
4 months, 1 week ago
Correct answer is D- there is not maintenance shell, the node shell is node specific, and the systemshell is for diag level commands.
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago