ExamTopics Logo
Mail Us[email protected]
Menu
Juniper Discussions
exam questions

Exam JN0-635 All Questions

View all questions & answers for the JN0-635 exam
Go to Exam

Exam JN0-635 topic 1 question 28 discussion

Actual exam question from Juniper's JN0-635
Question #: 28
Topic #: 1
[All JN0-635 Questions]

When would you use the port-overloading-factor 1 setting?

  • A. to enable the port-overloading
  • B. to disable the port-overloading
  • C. to map ports with 1:1 ratio for port-overloading
  • D. to set the maximum port-overloading capacity to 65,536
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
Reference:
https://www.juniper.net/documentation/en_US/junos/topics/reference/configuration-statement/security-edit-port-overloading-interface-source-nat.html
by joseph267 at April 19, 2022, 12:31 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
joseph267
3 months ago
B correct answer if port-overloading has been set to off to disable interface port overloading, and subsequently the port-overloading-factor is configured with any value greater than 1, the port-overloading-factor setting will override the port-overloading setting. (Configuring port-overloading-factor 1 is equivalent to configuring port-overloading off.)
upvoted 2 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago