ExamTopics Logo
Mail Us[email protected]
Menu
Juniper Discussions
exam questions

Exam JN0-663 All Questions

View all questions & answers for the JN0-663 exam
Go to Exam

Exam JN0-663 topic 1 question 86 discussion

Actual exam question from Juniper's JN0-663
Question #: 86
Topic #: 1
[All JN0-663 Questions]

You recently deployed CoS-based forwarding in your network, which uses OSPF as its IGP. You notice that the forwarding of traffic has not changed and is not following the path indicated within your configuration.
In this scenario, which statement explains this behavior?

  • A. The defined policy references IP addresses as the next-hops instead of interface names.
  • B. Load balancing has not been enabled under [edit forwarding-options].
  • C. The defined policy references interface names as the next-hops instead of IP addresses.
  • D. The defined policy has not been applied under [edit class-of-service forwarding-policy].
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
by mikkamilla at June 16, 2021, 8:08 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
mikkamilla
Highly Voted 3 years, 10 months ago
the right one is A When you configure CBF with OSPF as the interior gateway protocol (IGP), you must specify the next hop as an interface name or next-hop alias, not as an IPv4 or IPv6 address. This is true because OSPF adds routes with the interface as the next hop for point-to-point interfaces https://www.juniper.net/documentation/us/en/software/junos/cos/topics/concept/cos-configuring-cos-based-forwarding.html
upvoted 17 times
...
mohdema
Most Recent 2 years, 4 months ago
Selected Answer: A
See link given below An admin should change this
upvoted 1 times
...
Totalstranger
2 years, 8 months ago
Selected Answer: A
A base on the link below, https://www.juniper.net/documentation/us/en/software/junos/cos/topics/concept/cos-configuring-cos-based-forwarding.html
upvoted 2 times
...
Totalstranger
2 years, 8 months ago
Selected Answer: A
A is the answer base on the link provided by Ken Zo
upvoted 2 times
...
juniper_expert
2 years, 11 months ago
A is correct . CBF with OSPF must use next-hop as interface name
upvoted 3 times
...
ken_zo
3 years ago
C is correct https://www.juniper.net/documentation/us/en/software/junos/cos/topics/example/cos-based-forwarding-example-cos-config-guide.html
upvoted 1 times
Totalstranger
2 years, 8 months ago
Your link shows that the correct answer is A When you configure CBF with OSPF as the IGP, you must specify the next hop as an interface name, not as an IPv4 or IPv6 address.
upvoted 1 times
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago