Click the Exhibit button. You have an OSPF environment. You have recently added a router called R4 that is directly connected to R1 and R2. You discover that R4 is only peering with R2. Referring to the exhibit, how would you correct the peering?
A.
Adjust the Hello Interval on R1 and R2 to match the Hello Interval on R4.
B.
Change the MTU size on R1 and R2 to be 22 bytes higher than R4's MTU size.
C.
Adjust the Dead Interval on R4 to match the Dead Interval on R1 and R2.
D.
Adjust the Priority on R1 to be lower than the Priority on R4.
To adjust hello-interval will automatically convert the default dead-interval value into 4 times of the hello-interval that you just adjusted. However, you cannot do just by adjusting dead-interval to change the default hello-interval automatically. So basically I will select answer A.
To adjust hello-interval will automatically convert the default dead-interval value into 4 times of the hello-interval that you just adjusted. However, you cannot do just by adjusting dead-interval to change the default hello-interval automatically. So basically I will select answer A.
The hello interval and the dead interval optimize convergence times by efficiently tracking neighbor status. By lowering the values of the hello interval and the dead interval, you can increase the convergence of OSPF routes if a path fails. These intervals must be the same on all routing devices on a shared network.
upvoted 2 times
...
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
3574e4e
Highly Voted 10 months, 4 weeks agodre8051
Most Recent 1 month, 2 weeks agodre8051
1 month, 2 weeks agoquraitulain
4 months, 3 weeks agoquraitulain
4 months, 3 weeks agopiipo
6 months, 4 weeks agoGuru29
10 months agohbstyleboy
10 months, 1 week ago