Exam NSE4_FGT-7.0 topic 1 question 64 discussion

It's Port 2. Port 3 and 4 have packet loss so they are eliminated. Port 1 and Port 2 have no packet loss but because the strategy is Lower Qost the tie breaker is qost number. The lowest cost number will be selected.

Should this not be port 2 ? Port 4 and Port 3 not selected due to packet loss, Port 1 has higher cost. Leaving port 2.

clearly port-2. Why did i pay for this when most of the answers are wrong?!

port2 because it has no packet loss and lowest cost available

The interface that meets SLA targets is selected. When there is a tie, the interface with the lowest assigned cost is selected. FortiGate_Infrastructure_7.0_Study_Guide-Online – page 95 First must passed the target, after pass the cost y finally pass interface preference

port2 in my Opinion aswell

The correct answer is A. To determine the best path for traffic in Fortinet's SD-WAN implementation, a "lowest cost" algorithm is used that considers the cost metric associated with each available WAN link. In this case, Port 4 and 3 are eliminated due to packet loss, leaving Port 1 and Port 2 as the available paths. The next stage of elimination is based on the highest cost. Port 1 has a high cost of 15, which makes it less desirable than Port 2. Therefore, Port 1 is eliminated, and Port 2 is selected as the winner. For more information, please refer to the Fortigate Infrastructure 7.0 Study Guide, page 95.

Lower Cost (SLA) SLA Targets->Cost->Interface Preference. Fortigate Infrastructure 7.0 Study Guide, page 95

A is correct

C Port 4 is correct, the cost for port 4 is set to 1, so the lowest cost

Answer is A. Port 2 based on less the fact that it has no packet loss and a higher cost.

Lowest cost worked on Cost mattrix which is assigned on port, We don't focus on Latency part, and go with port4

port2 satisfies the SLA target requirement and has the lowest cost. page 95, FortiGate Infrastructure 7.0 study guide.

Port2 because has the lower cost and no packet lost.

porta 3 e 4 estão com perda de pacote o elegivél seria a porta 4 por te menor custo mais como estratégia de intelogência do sd-wan ele elegerá a proxima porta que esteja com custo e com menor perda que no caso é a 2.

Port 2- A

Does 0% is really 0.000000%? Does not mean less than 1% (<1%). Because if even a decimal above 0 means SLA is not met then in a real scenario is always going to be flapping.