Refer to the exhibit, which contains a screenshot of some phase-1 settings. The VPN is not up. To diagnose, the administrator enters the following CLI commands: However, the IKE real-time debug does not show any output. Why?
A.
The log-filter setting was set incorrectly. The VPN traffic does not match this filter.
B.
The administrator must enable the following real-time debug: diagnose debug application ipsec ""1.
C.
The debug output only shows pre-shared key, encryption, and authentication mismatch(es).
D.
The debug shows only error messages. If there is no output, then phase-1 and phase-2 configurations are matching.
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
Angel123
Highly Voted 4 years, 3 months agoDatBroNZ
Most Recent 3 years, 2 months agopollyy
4 years, 2 months ago