Exam FCSS_SASE_AD-23 topic 1 question 15 discussion

During initial provisioning, you can select fewer security sites than the maximum you are entitled to. In this case, upon each login, the FortiSASE portal prompts you to select up to the maximum number of security sites. If you add additional security sites using this prompt, then FortiSASE allows for increasing the number of security sites without FortiCare Support. FortiSASE may experience up to 10 minutes of downtime when you apply the entitlement. If any errors occur, FortiSASE cannot automatically rollback without FortiCare Support. For provisioning, you must select a minimum of two security sites for redundancy

Page 25 of the 23 guide in the fuzzy screen shot shows select 4.

Changed... correct is A. As per the Study Guide v 24, page 16: " During initial provisioning, you can select fewer security sites than the maximum you are entitled to"

at the pag 16 of study guide v24, look at the screenshot when provisioning the Fortisase, pay attention to the information 0/4 when provisioning the POP. It means you can chose up to 4 POPs

Correct answer is 2 per admin guide, "For provisioning, you must select a minimum of two security sites for redundancy."

Correct answer is 2.. Refer to Fortinet KB at the bottom of the page - https://docs.fortinet.com/document/fortisase/latest/administration-guide/751044/appendix-a-fortisase-data-centers#Number

Should be D, obviously, from the provisioning GUI in the SG p25.

FortiSASE_23_Administrator_Study_Guide-Online, slide on pg 25

4 PoPs were necessary in version 23, from version 24 one is sufficient

During FortiSASE provisioning, the FortiSASE administrator needs to configure at least one security point of presence (PoP). A single PoP is sufficient to get started with FortiSASE, providing the necessary security services and connectivity for users.

Answer is D = 4

I belive in FortiSASE v.23, you are required to put 4 since the FortiSASE provisioning process specifies "Please select (4) data centers to host PoPs..."