the answer is A. The question is about memeber utilization.
D is for interface utilzation. There is no mention of INTERFACE in the question. See 7.2 P322
The answer is D. see below output from that command:
Branch1 # diagnose sys sdwan intf-sla-log HUB1-VPN1
Timestamp: Wed Jun 4 11:33:48 2025, used inbandwidth: 659bps, used outbandwidth: 659bps, used bibandwidth: 1318bps, tx bytes: 7619104bytes, rx bytes: 7616338bytes.
Timestamp: Wed Jun 4 11:33:58 2025, used inbandwidth: 659bps, used outbandwidth: 659bps, used bibandwidth: 1318bps, tx bytes: 7619975bytes, rx bytes: 7617190bytes.
Timestamp: Wed Jun 4 11:34:08 2025, used inbandwidth: 659bps, used outbandwidth: 659bps, used bibandwidth: 1318bps, tx bytes: 7620775bytes, rx bytes: 7617990bytes.
A. diagnose sys sdwan sla-log → Incorrect, because this command does not exist in FortiGate CLI.
B. diagnose sys sdwan log → Incorrect, as it only provides general SD-WAN log information, not SLA-based utilization statistics.
C. diagnose sys sdwan health-check → Incorrect, as it provides real-time results of SD-WAN health checks but does not show historical statistics.
Thus, Option D is the correct answer because it retrieves historical SLA-based statistics for SD-WAN interfaces over the last 10 minutes.
D is correct, but wanted to clarify that A does in fact exist as a command in the CLI. It's shown on page SG 7.2 page 322. It's just not used for utilization of the members.
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
rtdtmtit
3 months, 3 weeks agoTIGERZ44
1 month agofa7474b
2 months, 3 weeks agof002a32
4 months, 2 weeks agofa7474b
2 months, 3 weeks agolucient
8 months, 2 weeks agoginmco
8 months, 2 weeks agotruserud
8 months, 3 weeks ago