Exam 301b topic 1 question 130 discussion

Actual exam question from F5's 301b

Question #: 130
Topic #: 1

An HA pair of LTM devices configured in Active-Standby mode stops responding to traffic and causes an outage. The Active device becomes Standby, but the partner device stays in Standby mode instead of taking over as Active. A reboot and restart of the services brings the LTM device to Active mode for a short time, but then it goes into Standby mode again.
Which two configuration components caused this condition? (Choose two.)

A. VLAN Fail-safe
B. System Fail-safe
C. Gateway Fail-safe
D. Switch Board Failure
E. Link down on Failover

Show Suggested Answer

Suggested Answer: AC 🗳️

by GVKD at Feb. 12, 2024, 11:34 p.m.

Comments

Submit Cancel

GVKD

4 months, 4 weeks ago

AC - Correct VLAN Fail-Safe: After the failsafe timer expires and the configured action is performed, the device remains in failsafe fault mode and cannot become active until network activity is detected on the VLAN. https://my.f5.com/manage/s/article/K13297 Gateway Fail-Safe: The Failover action is the optimal gateway fail-safe action. You can use the Reboot and Restart All actions when upstream equipment requires the BIG-IP system to drop the links to clear out their Address Resolution Protocol (ARP) cache or cause the interfaces to reset. https://my.f5.com/manage/s/article/K91881543

upvoted 1 times

...

Exam 301b All Questions

View all questions & answers for the 301b exam

Exam 301b topic 1 question 130 discussion

Comments

GVKD

SY0-701