ExamTopics Logo
Mail Us[email protected]
Menu
Dell Discussions
exam questions

Exam E20-393 All Questions

View all questions & answers for the E20-393 exam
Go to Exam

Exam E20-393 topic 1 question 28 discussion

Actual exam question from Dell's E20-393
Question #: 28
Topic #: 1
[All E20-393 Questions]

A service provider is installing a Unity storage system for an end-user. The end-user is concerned about network security and will not allow the service provider access to the network.
How can the service provider set a static IP address for the Unity storage system management interface?

  • A. Use the embedded InitCLI tool
  • B. Connect directly to the service ports and configure the networking through UEMCLI
  • C. Use an IPMI serial over LAN connection
  • D. Use the Connection Utility to create a configuration file
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
The svc_initial_config UEMCLI command sets up initial system configuration. It configures a management IP address when the Connection Utility (CU) is not available on the network. If an address is set, this command can also change the management IPv4 and IPv6 configuration mode. It attempts to configure the system with the given friendly name and/or network parameters.
Note: The Unisphere CLI (UEMCLI) is a tool that provides us with the CLI access to perform the same actions as one would on the Unisphere web interface.
References:
https://www.emc.com/collateral/TechnicalDocument/docu69328.pdf
(page 60)
by Veera_I at June 17, 2020, 3:06 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Veera_I
Highly Voted 4 years, 7 months ago
When setting up the system, and a network connection cannot be used, use the Unity Connection Utility to create a configuration file. Save the file to an usb drive, and put the drive into the usb port of the SP
upvoted 6 times
...
carico1980
Most Recent 3 years, 3 months ago
IPMI over lan connection
upvoted 3 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago