A network administrator cannot select the link to be used for failover when configuring an active/passive HA Cisco FTD pair. Which configuration must be changed before setting up the high availability pair?
A.
An IP address in the same subnet must be added to each Cisco FTD on the interface.
B.
The interface name must be removed from the interface on each Cisco FTD.
C.
The name Failover must be configured manually on the interface on each Cisco FTD.
D.
The interface must be configured as part of a LACP Active/Active EtherChannel.
absolutely B.
https://www.cisco.com/c/en/us/td/docs/security/firepower/660/fdm/fptd-fdm-config-guide-660/fptd-fdm-ha.html#concept_8C628FB71F0444A6BAC6D33FD72FB2EE#:~:text=you%20cannot%20specify%20an%20interface%20that%20is%20currently%20configured%20with%20a%20name
No, the correct answer is B.
The interface name must be removed from the interface on each Cisco FTD when configuring an active/passive HA pair. This is because when configuring failover, a dedicated interface is used for the failover link, and the interface name cannot be used for this purpose. Therefore, the interface name must be removed to allow the failover link to be configured properly.
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
Initial14
Highly Voted 3 months agotinyJoe
Most Recent 4 weeks agoTonymopar
3 months agotanri04
4 months, 1 week agoMevijil
5 months, 2 weeks agoSeawanderer
5 months, 2 weeks ago