Refer to the exhibit. An engineer must configure an ERSPAN tunnel that mirrors traffic from Linux1 on Switch1 to Linux2 on Switch2. Which command must be added to the destination configuration to enable the ERSPAN tunnel?
A.
(config-mon-erspan-dst-src)# erspan-id 172.16.10.10
B.
(config mon erspan-dst-src)# erspan-id 110
C.
(config-mon-erspan-dst-src)# no shut
D.
(config-mon-erspan-dst-src)# origin ip address 172.16.10.10
I think this question is wrong. The destination address is pointing to sw2 loop back when it’s suppose to be the Linux box. Shutdown is not configured either.
origin address is the source of the GRE tunnel used to encapsulate traffic in ERSPAN, and yeah you're right the no shut command needs to be configured to start the monitoring session. see https://networklessons.com/cisco/ccie-routing-switching-written/erspan. So I think your right this question is a little off.
upvoted 1 times
...
...
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
bendarkel
Highly Voted 1 year, 8 months ago[Removed]
Most Recent 2 months ago[Removed]
1 year agoHarwinderSekhon
1 year, 1 month agonli
1 year, 2 months agox3rox
1 year, 6 months agosam6996
1 year ago