Exam 200-301 topic 1 question 605 discussion

To allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password, the correct additional configuration is: B. R1(config)#username admin privilege 15 secret p@ss1234 R1(config)#line vty 0 4 R1(config-line)#login local Explanation: Option B provides the correct configuration for enabling Telnet access with local authentication. Here's a breakdown of the commands: R1(config)#username admin privilege 15 secret p@ss1234: This command creates a local username "admin" with privilege level 15 and sets the password as "p@ss1234". The privilege level 15 grants administrative access to the user. R1(config)#line vty 0 4: This command enters the configuration mode for the virtual terminal lines (vty) from 0 to 4, which are used for Telnet access. R1(config-line)#login local: This command enables local authentication for Telnet access on the vty lines, meaning the switch will use the locally configured username and password for authentication.

Answer is C. You need to configure enable secret command in order to connect to telnet

B is correct

Tested in my lab. B is the answer. However, the same configuration will not work on a router.

B. R1(config)#username admin privilege 15 secret p@ss1234 R1(config-if)#line vty 0 4 R1(config-line)#login local

B is right

Answer A Its the unique that enable telnet (transport input telnet)

The answer is B

question request a privilege execution and password but have not mentioned sec password. why need to use key word sec instead of password

....authenticate directly to enable privilege mode via Telnet using a local username and password

"authenticate directly"

My guess is C https://community.cisco.com/t5/other-network-architecture/how-do-i-set-telnet-password/td-p/42975

Level 15 is exec mode :)

B is correct. Level 15 is Privileged Exec Mode, which is what the question is asking about.