ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 350-601 All Questions

View all questions & answers for the 350-601 exam
Go to Exam

Exam 350-601 topic 1 question 24 discussion

Actual exam question from Cisco's 350-601
Question #: 24
Topic #: 1
[All 350-601 Questions]


Refer to the exhibit. All switches are configured with the default OSPF priority. Which configuration should be applied to ensure that the SW2 Cisco Nexus switch controls the LSA floods and advertises the network to the remaining nodes in the OSPFv2 area?

  • A. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 255
  • B. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 1
  • C. SW2# configure terminal SW2 (config)# router ospf 1 SW2 (config-router)# router-id 10.10.10.22
  • D. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 0
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
by MaxG at Sept. 14, 2021, 4:49 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
designated
Highly Voted 1 year, 1 month ago
The correct answer is A. A = 255 is the highest router priority B = It is the same (as we are doing nothing) C = Is not the highest router ID D = Ineligible to become the DR/BDR
upvoted 6 times
...
Zi04
Most Recent 2 weeks, 3 days ago
Selected Answer: A
Key points about OSPF priority 0: No DR election participation: When a router has a priority of 0, it will not be considered during the DR election process. Default priority is 1: The standard OSPF priority value for a router interface is usually set to 1. Higher priority means higher chance of becoming DR: A router with a higher priority value is more likely to be elected as the DR. Impact on network design:
upvoted 1 times
...
GuyThatTakesDumps
3 months, 3 weeks ago
Selected Answer: A
A is correct!
upvoted 3 times
...
MaxG
1 year, 4 months ago
A is correct. Priority in OSPF is mainly used to influence/determine a designated router/backup designated router for a network. By default, the priority is 1 on all routers. A router with a high priority will always win the DR/BDR election process. If there is a tie, a router with the highest router ID wins the election. The router with the second highest OSPF priority or router ID will become a BDR.
upvoted 4 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago