Exam 300-410 topic 1 question 200 discussion

Actual exam question from Cisco's 300-410

Question #: 200
Topic #: 1

Refer to the exhibit. A network administrator is using the DNA Assurance Dashboard panel to troubleshoot an OSPF adjacency that failed between Edge_NYC
Interface GigabitEthernet1/3 with Neighbor Edge_SNJ. The administrator observes that the neighborship is stuck in the exstart state.
How does the administrator fix this issue?

A. Configure to match the OSPF interface network types on both routers.
B. Configure to match the OSPF interface speed and duplex settings on both routers.
C. Configure to match the OSPF interface MTU settings on both routers.
D. Configure to match the OSPF interface unique IP address and subnet mask on both routers.

Show Suggested Answer

Suggested Answer: C 🗳️

by [deleted] at Aug. 5, 2021, 5:15 p.m.

Comments

Submit Cancel

yeyuno

Highly Voted 2 years ago

Neighbors Stuck in Exstart/Exchange State The problem occurs most frequently when you attempt to run OSPF between a Cisco router and another vendor router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces do not match. If the router with the higher MTU sends a packet larger that the MTU set on the neighboring router, the neighbor router ignores the packet. When this problem occurs, the output of the show ip ospf neighbor command displays output similar to what is shown in this figure.

upvoted 7 times

...

[Removed]

Most Recent 9 months, 1 week ago

Selected Answer: C

C is corerct

upvoted 2 times

...

[Removed]

3 years, 8 months ago

The given answer is correct

upvoted 2 times

...

Exam 300-410 All Questions

View all questions & answers for the 300-410 exam

Exam 300-410 topic 1 question 200 discussion

Comments

yeyuno

[Removed]

[Removed]

SY0-701