Refer to the exhibit. Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0/24 network?
default priority is 100 and its in preempt will be chosen as the active gateway, standby configured is 100, it will give back rights(if so to say) when R1 comes online
cisco#show standby
Ethernet0/0 - Group 10
State is Active
2 state changes, last state change 00:57:43
Virtual IP address is 172.16.113.254
Active virtual MAC address is 0000.0c07.ac0a
Local virtual MAC address is 0000.0c07.ac0a (v1 default)
Hello time 3 sec, hold time 10 sec
Next hello sent in 1.824 secs
Preemption enabled
Active router is local
Standby router is unknown
Priority 100 (default 100)
Group name is "hsrp-Et0/0-10" (default)
cisco#
*Dec 17 22:41:45.948: %HA_EM-6-LOG: CONF_CHANGE: Configuration changed
cisco#
cisco#sh run int Ethernet0/0
Building configuration...
Current configuration : 118 bytes
!
interface Ethernet0/0
ip address 172.16.113.2 255.255.255.0
standby 10 ip 172.16.113.254
standby 10 preempt
end
cisco#
No, A is correct. For R1 to be active, it must have higher priority. The default is 100, and setting a router to 90 will cause it to lose. Set R2 to 90, not R1.
This section is not available anymore. Please use the main Exam Page.350-401 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
[Removed]
10 months, 2 weeks agoNjavwa
1 year, 8 months agoadrian0792
1 year, 8 months agouhljeb
2 years agopmmg
2 years, 1 month agonushadu
2 years, 4 months agoAsymptote
2 years, 5 months agotimtgh
2 years, 11 months agotimtgh
2 years, 11 months agopierresadou
2 years, 11 months agoViolator
3 years, 1 month ago[Removed]
3 years, 11 months ago