Exam 350-401 topic 1 question 182 discussion

D & E is correct! The default priority value is 100. The router in the HSRP group with the highest priority value becomes the active router. The default hold time is 10 seconds for both versions of HSRP (v1 and v2), which is roughly three times the default hello time.

The default HSRP priority is 100 , the local router is the active router which is configured with an HSRP priority of '110,' while the standby router is configured with the default priority'100.' A "(configured <priority>)" statement shows up when a non-default priority is being used.

D & E are correct

The provided answers are correct. B is wrong because on this device priority is set to 110 which is not the default.

People saying B are not actually researching HSRP. Default priority is 100, same with VRRP. The current device in the example is the ACTIVE router and it says Priority 110. Question D states the STANDBY router is configured with default (100), which is correct. > Standby router is 10.0.3.242, priority 100 100 is indeed, the default hsrp priority so its D.

I see a lot of answers confusing the following lines of the command "show standby" ! Active router is local Standby router is 10.0.3.242, priority 100 (expires in 10.624 sec) Priority 110 (configured 110) ! The first line describes the local router, the one for which we are seeing the show command. The second line describes who the standby router, its ip address, and its configured priority The third line goes back to describe local router settings, and w e see that Priority is 110 and it even goes further and tells us the priority has been configured, otherwsie it would have said "default 100"

B. The device is configured with the default HSRP priority. The output shows that the configured priority is 110, which matches the default priority value. E. The device is using the default HSRP hello timer. The output states that the hello time is 3 seconds, which is the default hello timer value for HSRP.

D & E Correct! Standby has default priority value.

D and E are 100% correct.

Example: https://www.packetswitch.co.uk/cisco-hsrp-configuration-example/

for me its B&E

The standby device priority is 110 (default value is 100) So for me are correct B and E Regards

cisco#show standby Ethernet0/0 - Group 10 State is Active 2 state changes, last state change 00:40:46 Virtual IP address is 172.16.113.254 Active virtual MAC address is 0000.0c07.ac0a Local virtual MAC address is 0000.0c07.ac0a (v1 default) Hello time 3 sec, hold time 10 sec Next hello sent in 1.568 secs Preemption disabled Active router is local Standby router is unknown Priority 100 (default 100) Group name is "hsrp-Et0/0-10" (default) cisco#show running-config interface Ethernet0/0 Building configuration... Current configuration : 98 bytes ! interface Ethernet0/0 ip address 172.16.113.2 255.255.255.0 standby 10 ip 172.16.113.254 end cisco#

hsrp uses multicast: 224.0.0.2 v1, 224.0.0.102 v2, 224.0.0.18 vrrp. default hsrp hello time is 3 sec, hold timer is 10 sec

Standby router priority is 100, which is default

B-E true.

The given answer is correct