Refer to the exhibit. A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP-SW2. In which two of these ways can you design this solution? (Choose two.)
A.
Enable Y.1731 Connectivity Fault Management on the SP switches.
B.
E-LMI PDUs must be forwarded over VPLS.
C.
Cisco Discovery Protocol PDUs must be forwarded over the VPLS.
D.
Use upward maintenance endpoints on the SP switches.
E.
Enable IEEE 802.1ag Connectivity Fault Management on the SP switches.
AE - Y.1731 is the same as 802.1ag but with further monitoring capabilities
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.352-001 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
joshuat
4 years, 3 months ago