ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 100-105 All Questions

View all questions & answers for the 100-105 exam
Go to Exam

Exam 100-105 topic 1 question 29 discussion

Actual exam question from Cisco's 100-105
Question #: 29
Topic #: 1
[All 100-105 Questions]

What is one requirement for interfaces to run IPv6?

  • A. An IPv6 address must be configured on the interface.
  • B. An IPv4 address must be configured.
  • C. Stateless autoconfiguration must be enabled after enabling IPv6 on the interface
  • D. IPv6 must be enabled with the ipv6 enable command in global configuration mode.
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
To use IPv6 on your router, you must, at a minimum, enable the protocol and assign IPv6 addresses to your interfaces.
by [deleted] at April 2, 2025, 1:53 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Currently there are no comments in this discussion, be the first to comment!
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago