Exam 300-610 topic 1 question 243 discussion

Actual exam question from Cisco's 300-610

Question #: 243
Topic #: 1

Refer to the exhibit. A Cisco engineer is configuring Cisco Nexus 7000 Series Switches. To simplify initial configuration verification and vPC+/HSRP troubleshooting, the engineer configures the primary vPC+ peer device with the FHRP active router highest priority. The primary FHRP device responds to ARP requests, even though the secondary vPC+ device also forwards the data traffic. Which configuration enables the Layer 3 connectivity from each vPC+ peer device?

A. Configure a VLAN network interface for the same VLAN from both devices.
B. Ensure that the enhanced Layer 2 license has been installed.
C. Set a restore timer that delays the vPC+ restart.
D. Manually configure virtual MAC addresses for any FHRP protocol.

Show Suggested Answer

Suggested Answer: C 🗳️

by lurker8000 at Nov. 22, 2024, 5:59 a.m.

Comments

Submit Cancel

CoAsT_x

1 day, 20 hours ago

Selected Answer: C

C sounds good. https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/interfaces/configuration/guide/b-Cisco-Nexus-7000-Series-NX-OS-Interfaces-Configuration-Guide-Book/configuring-vpcs.html From Cisco NX-OS Release 4.2(1), you can use the delay restore command to configure a restore timer that delays the vPC coming back up until after the peer adjacency forms and the VLAN interfaces are back up. This feature enables you to avoid packet drops when the routing tables might not be converged before the vPC is once again passing traffic. Use the delay restore command to configure this feature.

upvoted 1 times

...

lurker8000

1 month, 3 weeks ago

I'll go with A on this one

upvoted 1 times

...

Exam 300-610 All Questions

View all questions & answers for the 300-610 exam

Exam 300-610 topic 1 question 243 discussion

Comments

CoAsT_x

lurker8000

SY0-701