Which of the following are methods EIGRP uses to initially populate (seed) its EIGRP topology table, before learning topology data from neighbors? (Choose two.)
A.
By adding all subnets listed by the show ip route connected command
B.
By adding the subnets of working interfaces over which static neighbors have been defined
C.
By adding subnets redistributed on the local router from another routing source
Suggested Answer:D. By adding all subnets listed by the show ip route static command🗳️
Other than the two listed correct answers, the local router also adds connected routes for which the network command matches the corresponding interfaces, so it may not add all connected routes. Also, EIGRP does not add static routes to the EIGRP topology table, unless those routes are redistributed.
B. By adding the subnets of working interfaces over which static neighbors have been defined
C. By adding subnets redistributed on the local router from another routing source
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.300-101 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
diegonamaste
5 years, 2 months ago