Exam 300-101 topic 2 question 458 discussion

Actual exam question from Cisco's 300-101

Question #: 458
Topic #: 2

[All 300-101 Questions]

Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?

A. Disable CDP on the interface.
B. Execute the vpdn enable command.
C. Execute the no switchport command.

Show Suggested Answer

Suggested Answer: D. Enable QoS FIFO for PPPoE support. 🗳️
Enabling PPPoE in a VPDN Group -
Perform this task to enable PPPoE in a virtual private dial-up network (VPDN) group.

Restrictions -
This task applies only to releases prior to Cisco IOS Release 12.2(13)T.

SUMMARY STEPS -
1. enable
2. configureterminal
3. vpdn enable
4. vpdn-groupname
5. request-dialin
6. protocolpppoe

DETAILED STEPS -

Command or Action Purpose -
Step 1 enable Enables privileged EXEC mode.

Example: Enter your password if -
Router> enable prompted.
Step 2 configureterminal Enters global configuration mode.
Example:

Router# configure terminal -

Step 3 vpdn enable -

Enables virtual private dialup -
Example: networking.

Router(config)# vpdn enable -
Step 4 vpdn-groupname Associates a VPDN group with a Example: customer or VPDN profile.

Router(config)# vpdn-group -
group1
Step 5 request-dialin Creates a request-dialin VPDN Example: subgroup.
Router(config-vpdn)# request-
dialin
Step 6 protocol pppoe Enables the VPDN subgroup to

Example: establish PPPoE -
Router(config-vpdn-req-
in)# protocol pppoe
Reference:
http://www.cisco.com/en/US/docs/ios/12_2t/12_2t2/feature/guide/ftpppoec_support_TSD_Island _of_Content_Chapter.html

by diegonamaste at Feb. 20, 2020, 1:11 p.m.

Comments

Submit Cancel

diegonamaste

5 years, 2 months ago

B. Execute the vpdn enable command.

upvoted 1 times

...

Exam 300-101 All Questions

View all questions & answers for the 300-101 exam

Exam 300-101 topic 2 question 458 discussion

Comments

diegonamaste

SY0-701