ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 300-510 All Questions

View all questions & answers for the 300-510 exam
Go to Exam

Exam 300-510 topic 1 question 216 discussion

Actual exam question from Cisco's 300-510
Question #: 216
Topic #: 1
[All 300-510 Questions]

What is one of the purposes of a default Multicast Distribution Tree?

  • A. to handle high-bandwidth source streams
  • B. to define the RP for PIM sparse mode and the different leafs
  • C. to offload traffic from data MDT
  • D. to support control traffic between different VRFs
Show Suggested Answer Hide Answer
Suggested Answer: C 🗳️
by snowbow at May 24, 2024, 7:28 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
snowbow
5 months ago
Selected Answer: D
Data MDT is used to offload data from the default.. not the other way around. https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/17-6/configuration_guide/ip_mcast_rtng/b_176_ip_mcast_rtng_9500_cg/mldp_based_mvpn.html MLDP creates the MDTs as follows: The default MDT uses MP2MP LSPs. Supports low bandwidth and control traffic between VRFs. The data MDT uses P2MP LSPs. Supports a single high-bandwidth source stream from a VRF.
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago