While troubleshooting an EIGRP neighbor adjacency problem, the network engineer notices that the interface connected to the neighboring router is not participating in the EIGRP process. Which action resolves the issue?
A.
Configure EIGRP metrics on interface FastEthemet0/3.
B.
Configure the network command under EIGRP address family vrf CLIENT1.
C.
Configure the network command under EIGRP address family ipv4.
D.
Configure the network command to network 172.16.0.1 0.0.0.0.
Should be C:
R7(config)#router eigrp 100
R7(config-router)#add
R7(config-router)#address-family ?
ipv4 Address family
R7(config-router)#address-family ip
R7(config-router)#address-family ipv4 ?
unicast Address Family Modifier
vrf Specify parameters for a VPN Routing/Forwarding instance
<cr>
R7(config-router)#address-family ipv4 vr
R7(config-router)#address-family ipv4 vrf ?
WORD VPN Routing/Forwarding instance name
Peak Cisco. The old trap or typo?
A. Nope.
B. There is no "address family vrf CLIENT1." however ...
C. There will be an "address family *ipv4* vrf CLIENT1."
D. Nope
Actual answer is a combination of B and C.
Address-family ipv4 vrf 'name'
upvoted 2 times
...
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
Tester948
Highly Voted 1 year, 4 months agoZamanR
Highly Voted 1 year, 3 months ago1chung
Most Recent 6 days, 5 hours ago1chung
6 days, 5 hours agoANEE167
7 months, 1 week agotubirubs
7 months, 1 week ago[Removed]
8 months, 1 week agodapardo
9 months, 1 week agoyoxivi7892
1 year ago[Removed]
1 year, 3 months ago