Exam 350-801 topic 1 question 53 discussion

Answer is B: This snippet is captured from the link below: "Now that you have selected the hardware and protocol used, you need to configure the Domain Name, Cisco Unified Communications Manager Group, and the Module Information. These are the major fields that are required to register an endpoint via MGCP." So Cisco has listed the order as [Select Hardware, Protocol then FQDN/Hostname]. in the question, we can see it already told you that Hardware is: VG320, Protocol is :MGCP , the next step has to be Specify FQDN/Hostname https://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/214635-configure-and-troubleshoot-mgcp-gateways.html

B in incorrect because adding the hostname or FQDN is before adding the Gateway to the data base (ie, "save" and "apply conf"). The correct answer must be C. Reference: https://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/214635-configure-and-troubleshoot-mgcp-gateways.html

Should be B, when you add a new gateway, and fill in the fields in the configuration page in order, the domain name is the first required item to fill.

from: https://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/214635-configure-and-troubleshoot-mgcp-gateways.html Answer is B

After selecting VG320 as the device type and MGCP as the protocol for a new gateway device in Cisco UCM, the next step to add the gateway to the Cisco UCM database is to configure the module in slot 0 of the new gateway1. This involves specifying the appropriate slots and vendor interface cards (VICs) for the gateway. So, the correct action required would be: C. Configure the module in slot 0 of the new gateway.

As per the attached below link , answer is C https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_01001.html Configure MGCP (IOS) Gateway Perform the following procedure to add and configure an MGCP (IOS) gateway on the Unified Communications Manager.

The answer is B. https://community.cisco.com/t5/collaboration-knowledge-base/mgcp-gateway-integration-with-cucm-and-pstn-service-provider/ta-p/3116588#toc-hId-1719765046 "Step1: Enter the host name or fully qualified domain name (FQDN) of the gateway in the Domain name field. If a domain name is specified in the Cisco router you must provision an FQDN. If the FQDN specified in the CUCM does not match the “host name” dot “domain name” of the Cisco IOS router, then end point will never register. A router with the host name of Router1 and domain name of highpoint.com would have an FQDN of Router1.highpoint.come" You can't use the IP address of the gateway either, so as written, B is correct. You need to configure a module to get the ports themselves to register, but not for the gateway to be simply entered into the database, which is what the question is asking.

why is it C?

B is correct per https://community.cisco.com/t5/collaboration-knowledge-base/mgcp-gateway-integration-with-cucm-and-pstn-service-provider/ta-p/3116588

the answer is C check your CUCM Configuration

for me, B is correct

my wrong,B is correct

must c