You have used the "set inactivity-timeout 120" command to prevent the session to be disconnected after 10 minutes of inactivity. However, the Web session is being disconnected after 10 minutes. Why?
A.
The idle timeout for the web session is specified with the “set web session-timeout" command.
B.
The number specified is the amount of the idle timeout in seconds rather than in minutes. So you have to use the command "set inactivity-timeout 600" instead.
C.
Probably, you have forgotten to make sure that nobody is accessing the management server via the SmartConsole which locks the management database.
D.
The number of minutes is correct. Probably, you have forgotten to save this setting with the "save config" command.
cpdcgw01> set web session-timeout
Specifies the inactivity time (in minutes) after which the HTTP session
will be terminated. Range: Integers between 1 and 720
inclusive.
Default: "15".
cpdcgw01> set inactivity-timeout
Specifies inactivity timeout for shells assigned to users.
Range: 720-1
Default: 10
answer A
just double checked on my LAB
LABFW1> show web s
session-timeout - Web configuration tool Session timeout in minutes
ssl-port - Web configuration tool SSL port number
ssl3-enabled - Allow using SSL3 to access the web configuration tool
LABFW1> show web se
LABFW1> show web session-timeout
WebSessionTimeout 10
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
anasttom
2 months agoJosh_12344
3 months agorabbirobert
7 months agogperes
9 months, 2 weeks agoGendeebongz
9 months, 4 weeks agovgs2023
10 months, 3 weeks agoorion_son30
11 months ago18408
11 months, 2 weeks ago