ExamTopics Logo
Mail Us[email protected]
Menu
Checkpoint Discussions
exam questions

Exam 156-315.80 All Questions

View all questions & answers for the 156-315.80 exam
Go to Exam

Exam 156-315.80 topic 1 question 19 discussion

Actual exam question from Checkpoint's 156-315.80
Question #: 19
Topic #: 1
[All 156-315.80 Questions]

You noticed that CPU cores on the Security Gateway are usually 100% utilized and many packets were dropped. You don't have a budget to perform a hardware upgrade at this time. To optimize drops you decide to use Priority Queues and fully enable Dynamic Dispatcher. How can you enable them?

  • A. fw ctl multik dynamic_dispatching on
  • B. fw ctl multik dynamic_dispatching set_mode 9
  • C. fw ctl multik set_mode 9
  • D. fw ctl multik pq enable
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
by vhick at July 20, 2019, 6:20 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
bobby14
Highly Voted 2 years, 11 months ago
R77.30 exam - correct answer is C R80. exam - correct answer is A
upvoted 13 times
...
Ang7
Highly Voted 3 years, 6 months ago
According to the reference link, CoreXL Dynamic Dispatcher is disabled by default in R77.30 and the command is: fw ctl multik set_mode 9 However, in R80+, CoreXL Dynamic Dispatcher is enabled by default, and the command is: fw ctl multik dynamic_dispatching on So both are correct, depending on your version. Which one does the exam count as correct then?
upvoted 7 times
secadmin44
3 years, 2 months ago
In a real exam always the answer to the current version is right. Keep this is mind! So in this case the answer A for R80+ is right.
upvoted 2 times
...
...
4zh
Most Recent 5 months, 2 weeks ago
if you have 100% CPU and much drops - you need to optomize drops)) :-D this problem much more complicated...
upvoted 1 times
...
kambata
7 months, 2 weeks ago
Selected Answer: A
+For R80.10 and HIGHER: " [[email protected]:0]# fw ctl multik dynamic_dispatching on New mode is: On Please reboot the system [[email protected]:0]# "
upvoted 2 times
...
aharihara
1 year, 3 months ago
Selected Answer: A
https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261
upvoted 2 times
...
vhick
4 years ago
For R80, the command to enable it is # fw ctl multik dynamic_dispatching on so, A is the correct answer
upvoted 6 times
Degenhardt
3 years, 9 months ago
You're right. Reference: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261
upvoted 2 times
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago