Exam 156-315.80 topic 1 question 86 discussion

The answer is here : https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261#CoreXL%20Dynamic%20Dispatcher For r77 : fw ctl multik set_mode 0 For r80.10+ : fw ctl multik dynamic_dispatching on So this is a r77 question and answers. None of them is correct in r80.10+

[Expert@MIT-GW:0]# fw ctl multik set_mode 9 Usage: fw ctl multik stat fw ctl multik start fw ctl multik stop fw ctl multik utilize fw ctl multik print_heavy_conn fw ctl multik print_heavy_conn -v fw ctl multik heavy_conn_analyzer fw ctl multik get_instance [command args...] fw ctl multik dynamic_dispatching [command args...] fw ctl multik prioq [command args...] fw ctl multik print_bl [command args...] fw ctl multik gconn [command args...] fw ctl multik print_ghtab_pending_info [command args...]

Starting in R80.10 Priority queues and dynamic dispatcher are NO longer related. Command "fw ctl multik set_mode" applies only to R77. For R80.X there is NO command that will enable both priority queues and dynamic dispatcher

To fully enable Dynamic Disp atcher on a Security Gateway, run the following command in Expert mode and then reboot: fw ctl multik dynamic_dispatching on Page 418 CCSE Book

D is correct. When Dynamic Dispatcher is enabled, the Firewall Priority Queues feature in each CoreXL FW instance is also fully enabled. https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105261

[Expert@MyGW:0]# fw ctl multik prioq Current mode is Off Available modes: 0. Off 1. Eviluator-only 2. On Choose the desired mode number: (or 3 to Quit)

fw ctl multik set_mode 9

The question refers to R77.30 and below version and the answer is correct. For R80 and above-refer to the following - https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk105762&partition=Basic&product=Security

"fw ctl multik set_mode 9" was the R77.30 method of enabling this feature vs using "fw ctl multik dynamic_dispatching on" on R80.10+.

I think it's C R80+