Exam 156-315.81 topic 1 question 61 discussion

B, C and D definetly ARE reason for synchronization issues...I'll go with A and I think the trick here is that you configure a UNIQUE ip PER management, meaning that the IPs are different

A NOT D: https://support.checkpoint.com/results/sk/sk39345 General restrictions for Primary and Secondary Security Management servers: - The SmartEvent Software Blade can only be enabled on the active server in Management High Availability environment - Must have identical Check Point versions and identical hotfixes installed. To see the build number, run cpinfo -y FW1 - Must have identical products installed (i.e, Management HA is not supported between a Standalone machine and machine that runs only Security Management server)

A is correct. It won't matter if they have unique IP addresses. The other answers would cause issues.

A is the one that not is a reason.

NOT, answer A

Selected Answer: A

Sync issues: • Hardware clocks do not match, even with adjustments for different time zones • The products installed on the servers do not match; one device is a Standalone Server while the other is only a Security Management Server • The same upgrade path was not followed; the primary management server was upgraded while the secondary server was clean installed directly to the new version • There is a network connectivity failure between the servers • Servers are in Collision Mode. Two servers, both in active state cannot be synchronized either automatically or manually