When an Arista switch boots for the first time, ZTP is enabled. The switch sees that there is no startup-config, so it configures all interfaces with the no switchport command, then sends out DHCP queries on any Ethernet and Management interfaces.
Arista Warrior 2 confirms this (gksong is correct). "When a switch boots in ZTP mode, it configures all the Ethernet and Management interfaces with the no switchport command.." Chapter 25 Section: Booting with ZTP.. page 305..
upvoted 2 times
...
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
manhtran93
Highly Voted 1 year, 12 months agogksong
Highly Voted 2 years, 2 months agonetwork_guru
Most Recent 11 months, 1 week ago